L size
△ The ear pads may float slightly.
◎ Easy
× Impossible
If you wear it for a long time, the ear pads may be deformed, so it is recommended to remove the cover and store it after use.
This headphone is an over-ear headphone from "House of Marley," which manufactures audio equipment based on thorough environmental considerations. Its body uses a lot of wood and recycled metal, and even the few plastic parts are made of recycled plastic. While being eco-friendly, it also boasts a refined and stylish design.
Points when attaching the cover:
1. Do not cover too deeply
If you cover too deeply, the tension of the cover becomes strong, making it difficult for ears to fit into the ear cups, and you may feel a pressure on your ears when wearing.
Instead of covering the entire earpad, it is recommended to cover it shallowly so that the rubber part of the cover comes to the side of the earpad. (※ Please refer to the above installation photo)
2. Position the cover vertically
This cover has a different stretch rate vertically and horizontally, and it stretches better vertically. Since this headphone has a slightly elongated ear pad, it's better to position the cover vertically (in the direction that stretches well) to improve comfort.
To position the cover vertically, attach it so that the seam of the rubber band of the cover comes to the top (or bottom) of the cup. This allows you to set the cover's direction vertically.
3. Stretch before wearing
After attaching the cover, stretch the fabric inside the earpad by hand before wearing the headphones. This weakens the tension of the cover and improves comfort. If you feel pressure on your ears due to the cover, please try this method.
Also, because this headphone has relatively low earpad pressure, the tension of the cover might lift the earpad. Please be aware of this point when purchasing the cover.
(Tested by: Masayuki Hayashi)